MPU-6050 Not Found

Hi, I tried to use a MPU-6050 with an Arduino Nano, connected the SDA to A4, SCL to A5, GND to GND, and VCC to 5V. I ran this code, and it says

Adafruit MPU6050 test!
Failed to find MPU6050 chip.

I can't figure out what is wrong, I tried to ran the I2C scanner and it worked just fine and outputed I2C device found at address 0x68 !
done.
I would really appreciate it if somone knows how to fix this issue

#include <Adafruit_MPU6050.h>
#include <Adafruit_Sensor.h>
#include <Wire.h>

Adafruit_MPU6050 mpu;

void setup(void) {
  Serial.begin(115200);
  while (!Serial)
    delay(10); // will pause Zero, Leonardo, etc until serial console opens

  Serial.println("Adafruit MPU6050 test!");

  // Try to initialize!
  if (!mpu.begin()) {
    Serial.println("Failed to find MPU6050 chip");
    while (1) {
      delay(10);
    }
  }
  Serial.println("MPU6050 Found!");

  //setupt motion detection
  mpu.setHighPassFilter(MPU6050_HIGHPASS_0_63_HZ);
  mpu.setMotionDetectionThreshold(1);
  mpu.setMotionDetectionDuration(20);
  mpu.setInterruptPinLatch(true);	// Keep it latched.  Will turn off when reinitialized.
  mpu.setInterruptPinPolarity(true);
  mpu.setMotionInterrupt(true);

  Serial.println("");
  delay(100);
}

void loop() {

  if(mpu.getMotionInterruptStatus()) {
    /* Get new sensor events with the readings */
    sensors_event_t a, g, temp;
    mpu.getEvent(&a, &g, &temp);

    /* Print out the values */
    Serial.print("AccelX:");
    Serial.print(a.acceleration.x);
    Serial.print(",");
    Serial.print("AccelY:");
    Serial.print(a.acceleration.y);
    Serial.print(",");
    Serial.print("AccelZ:");
    Serial.print(a.acceleration.z);
    Serial.print(", ");
    Serial.print("GyroX:");
    Serial.print(g.gyro.x);
    Serial.print(",");
    Serial.print("GyroY:");
    Serial.print(g.gyro.y);
    Serial.print(",");
    Serial.print("GyroZ:");
    Serial.print(g.gyro.z);
    Serial.println("");
  }

  delay(10);
}

5 posts - 5 participants

Read full topic